We conduct a high-resolution seismic tomography for the crustal P and S-wave velocities of Yunnan region in southwestern China. Waveforms recorded at 128 broadband stations from 131 regional earthquakes of moment magnitudes 3.9−5.5 occurring between 2009 and 2021 are used to obtain traveltime residuals by the cross-correlation between records and synthetics. Using the regional community velocity model SWChinaCVM‐1.0 as the initial model, we carry out a three-stage iterative adjoint tomography, progressing from the longer period band of 50–20 s to shorter-period bands of 30–10 s and 30–5 s. The final model shows general consistency in the spatial patterns of P- and S-wave velocity anomalies. Widespread low-velocity anomalies with high-Vp/Vs ratios in the mid and lower crust in the region suggest a mix of weak materials of the mid-lower crustal flow from under the Tibetan Plateau with hot materials of the upwelling from the deep mantle plume that led to the Emeishan Large Igneous Province. Localized velocity and Vp/Vs ratio anomalies also reveal that the Lijiang-Xiaojinhe Fault Zone appears to be confined in the upper crust, while the Anninghe-Zemuhe Fault Zone and the Xiaojiang Fault Zone are both whole-crust structures reaching the Moho interface. The Red River Fault Zone, a whole-crust fault, separates the Yangtze Craton to the northeast from the Indo-China Block to the southwest. The main fault zones, the decoupling between the crustal and uppermost mantle parts, and the wide-spreading weak mid-lower crustal materials mutually interact, all contributing to the tectonic evolution of the entire region.

We conduct a high-resolution seismic tomography for the crustal P and S-wave velocities of Yunnan region in southwestern China. Waveforms recorded at 128 broadband stations from 131 regional earthquakes of moment magnitudes 3.9−5.5 occurring between 2009 and 2021 are used to obtain traveltime residuals by the cross-correlation between records and synthetics. Using the regional community velocity model SWChinaCVM‐1.0 as the initial model, we carry out a three-stage iterative adjoint tomography, progressing from the longer period band of 50–20 s to shorter-period bands of 30–10 s and 30–5 s. The final model shows general consistency in the spatial patterns of P- and S-wave velocity anomalies. Widespread low-velocity anomalies with high-Vp/Vs ratios in the mid and lower crust in the region suggest a mix of weak materials of the mid-lower crustal flow from under the Tibetan Plateau with hot materials of the upwelling from the deep mantle plume that led to the Emeishan Large Igneous Province. Localized velocity and Vp/Vs ratio anomalies also reveal that the Lijiang-Xiaojinhe Fault Zone appears to be confined in the upper crust, while the Anninghe-Zemuhe Fault Zone and the Xiaojiang Fault Zone are both whole-crust structures reaching the Moho interface. The Red River Fault Zone, a whole-crust fault, separates the Yangtze Craton to the northeast from the Indo-China Block to the southwest. The main fault zones, the decoupling between the crustal and uppermost mantle parts, and the wide-spreading weak mid-lower crustal materials mutually interact, all contributing to the tectonic evolution of the entire region.

The southeastern margin of the Tibetan Plateau has undergone complex deformation since the Cenozoic, resulting in a high level of seismicity and seismic hazard. Knowledge about the seismic anisotropy provides important insight about the deformation mechanism and the regional seismotectonics beneath this tectonically active region. In this study, we conduct fullwave multi-scale tomography to investigate the seismic anisotropy in the southeastern margin of the Tibetan Plateau. Broadband records at 111 permanent stations in the region from 470 teleseismic events are used to obtain 5,216 high-quality SKS splitting intensity measurements, which are then inverted in conjunction with 3D sensitivity kernels to obtain an anisotropic model with multi-scale resolution. Resolution tests show that our dataset recovers anisotropy anomalies reasonably well on the scale of 1º x 1º horizontally and ~100 km vertically. Our result suggests that in the southeastern margin of the Tibetan Plateau the deformation in the lithosphere and asthenosphere are decoupled. The anisotropy in the lithosphere varies both laterally and vertically as a result of dynamic interactions of neighboring blocks as well as lithospheric reactivation. The anisotropy in the asthenosphere largely follows the direction of regional absolute plate motion. The SKS splittings observed at the surface are shown to be consistent with the vertical integral of our depth-dependent anisotropy model over lithospheric and asthenospheric depths.

To advance the understanding of the tectonic processes shaping the African continent, we construct the first continental-scale shear-wave velocity (Vs) model of the crust and uppermost mantle from joint analysis of ambient seismic noise and earthquake data recorded by ~1529 broadband seismic stations located in Africa, Arabia, and Europe from 1987 to 2018. We apply the widely used ambient noise cross-correlation and earthquake two-station methods to retrieve the fundamental-mode Rayleigh-wave group and phase velocity dispersions in the period range of 5 – 50 s which are jointly inverted using the neighbourhood algorithm to build a new three-dimensional Vs model with associated uncertainties. The inclusion of relatively short-period dispersion data from ambient seismic noise allows us to achieve better resolution at shallow depth and obtain a more accurate model than previous global and continental-scale studies, revealing lithospheric structures that correlate well with known tectonic features. In sparsely instrumented regions of north-central Africa, our model provides seismic evidence for the existence of cratonic remnants beneath thick sediments within the poorly imaged Sahara Metacraton and reveals unique mantle upwelling beneath hotspots, suggesting that they may be fed by unconnected plumes. The estimated crustal thickness varies among and within tectonic provinces and shows no clear evidence for the secular variation in crustal genesis. Our new model has the potential to serve as a preliminary reference velocity model for Africa and is useful for practical applications, including monitoring of the Comprehensive Nuclear-Test-Ban Treaty, geodynamic modeling as well as seismic hazard analysis.

The Xiaojiang Fault (XJF) Zone locates in the southeastern of Tibetan Plateau and defines the boundary between the South China and Sichuan-Yunnan blocks. Historical large earthquakes were hosted on the XJF, though its seismic hazard in the near future is under debate. In this study, we utilize portable broad-band seismic network to unravel the microseismic activities along XJF, and to further investigate the fault structures and their properties. Adopting PALM, a newly developed earthquake detection algorithm, we obtained ~13,000 relocated events. The micro-seismicity reveals widespread off-fault structures showing conjugate geometry, while the major faults present low seismicity. The fault branches conjugate to the main-fault present intensive microseismicity, which hosts repeating events and presents high b-value. Regional GPS stations reflect slips are mostly concentrated along the XJF, while the slip rate on off-fault branches correlates with seismic activities on these structures. Combining with other recent seismological and magnetotellurics evidences, we suggest a low strength on these off-fault structures, which may partially release tectonic stress loading and serve as a barrier for future big earthquakes. On the XJF, the microseismic events are clustered on the fault junctions with low b-value. A special set of clusters between 25°N to 25.5°N show an along-strike variation of depth from 10 to 25-km, imaging the boundary between creeping and locked fault portions. We revisit the seismic hazard problem of XJF, and conclude that XJF is at the late stage of inter-seismic period.

Intra-continental dip-slip earthquakes often occur in the orogen and rift zones with complex tectonics, providing rare opportunities to illuminate the deformation and evolution of continental structures. However, due to the sparse seismological and geodetic observations, such earthquakes are less studied. Here, we report the fault geometries of two dip-slip earthquakes recently occurred in Southern Tian Shan and the Mongolia-Baikal rift zone revealed by InSAR . The 2020 Mw6.0 Jiashi earthquake occurred in the Keping-tage fold-and-thrust belt in southwest Tian Shan. This region is seismically active, yet most well-recorded earthquakes occurred south of the mountain front. The lack of large earthquakes beneath the belt thus hinders our understanding of the orogenic process to the north. Combining InSAR measurements and relocated aftershocks, we found that a fault model involving a shallow thrust fault and two deeper faults can best reconcile the surface deformation and aftershock distribution. Stress analysis suggests that slips on the shallow fault reactivated the older basement structures at depth. Our results reflect the basement-involved shortening activated by a thin-skinned thrust faulting event with surface deformation, implying a southward orogenic process of the southwest Tian Shan. The 2021 Mw6.7 Lake Hövsgöl earthquake occurred in the Mongolia-Baikal rift zone (MBRZ), which is located in the northern tip of the northern Mongolia, and is bounded by the Tibet Plateau orogenic belt and the Siberian Platform. Using the Bayesian inversion method we derived a fault plane with two slip patches, one is mainly strike slip and the other is mainly normal slip component. The correlation between the observed and predicted displacements by the single fault model is 97.46%. Coulomb stress analysis shows that the 2021 event has a triggering effect on the western segment of the Tunka Fault to the north, where no large earthquakes have occurred since the 1905 M8+ earthquake, raising the potential for seismic risk in this region.

We conduct a tomographic inversion for the 3-D P-wave velocity structure in the lower crust and uppermost mantle of the Sichuan-Yunnan region in the southeastern margin of the Tibetan Plateau. A total of 43,450 reliable arrival times of P waves are picked from over 300,000 regional seismic records using an automatic algorithm based on deep learning. A two-stage iterative inversion process is adopted in which events are relocated in the process, leading to a significant reduction in traveltime residuals. A statistical resolution matrix analysis suggests that our model has an optimal spatial resolution length of ~0.4° in the lower crust and ~0.2° in the uppermost mantle. Our 3-D model shows that both the lower crust and uppermost mantle in the region are characterized by strong lateral heterogeneities. The unusually low velocities in the lower crust may indicate the existence of lower crustal flow, whereas the high velocity anomalies in the uppermost mantle in and around the Sichuan-Yunnan Rhombic Block may be an important factor in preventing the ductile materials in the lower crust moving eastward. Our model also indicates a coupling between the surface deformation and the material flow in the lower crust. Finally, the lower crustal flow may influence the materials immediately below the Moho interface beneath the Sichuan-Yunnan Rhombic Block, and the crust-mantle transition zone in the eastern margin of Songpan-Ganzi Block may be influenced by both the lower crustal flow and the upwelling warm materials from below.

We reveal a slip-partitioning rupture on the North Hovsgol Fault during the 2021 Mw6.7 Lake Hovsgol, Mongolia earthquake. Left-lateral motions on the Mondy Fault north of the epicenter likely controlled the observed slip partitioning pattern. The earthquake highlights the non-negligible role of the bounding strike-slip fault in the formation and evolution of oblique rift.

The Keping-tage fold-thrust belt in southwest Tian Shan is seismically active, yet most well-recorded earthquakes occurred south of the mountain front, hindering our understanding of the orogenic process to the north. The 2020 Mw6.0 Jiashi earthquake is an important event with surface deformation in the nappe structure well illuminated by InSAR. Here, we employ the surface deformation and relocated aftershocks to investigate the fault slip distribution associated to this event. Further added by an analysis of Coulomb stress changes, we derive a fault model involving slips on a shallow low-angle (~10º) north-dipping thrust fault as well as on a left-lateral tear fault and a high-angle south-dipping reverse fault in mid crust. Our results reflect the basement-involved shorterning activated by a thin-skinned thrust faulting event with the surface deformation implying the basin-ward orogenic process of the southwest Tian Shan.