Satellite radar backscatter has the potential to provide useful information about the progression of volcanic eruptions when optical, ground-based, or radar phase-based measurements are limited. However, backscatter changes are complex and challenging to interpret: explosive deposits produce different signals depending on pre-existing ground cover, radar parameters and eruption characteristics. We use high temporal- and spatial-resolution backscatter imagery to examine the emplacement and alteration of pyroclastic flows, lahars, and ash from the June 2018 eruption of Volcan de Fuego, Guatemala, drawing on observatory reports and rain gauge data to ground truth our observations. We use dense timeseries of backscatter to reduce noise and extract deposit areas. Backscatter decreases where six flows were emplaced on 3 June 2018. In Barranca Las Lajas, we measured a 11.9-km-long flow that altered an area of 6.3 km2; and used radar shadows to estimate a thickness of 10.5 +/- 2 m in the lower sections. The 3 June eruption also changed backscatter over an area of 40 km2, consistent with ashfall. We use transient patterns in backscatter timeseries to identify nine periods of high lahar activity in B. Las Lajas between June and October 2018. We find that the characterisation of subtle backscatter signals associated with explosive eruptions is assisted by (1) radiometric terrain calibration, (2) speckle correction, and (3) consideration of pre-existing scattering properties. Our observations demonstrate that SAR backscatter can capture both the emplacement and subsequent alteration of a range of explosive products, allowing the progression of an explosive eruption to be monitored.