loading page

Transient Power Overshoot Suppression Strategy of Generalized Droop Control with Constrained RoCoF
  • +2
  • Qinghui Wu,
  • Hengwei Lin,
  • Chunjiang Zhang,
  • xiaoyu Zhang,
  • Fuxi Wang
Qinghui Wu
Yanshan University School of Electrical Engineering

Corresponding Author:[email protected]

Author Profile
Hengwei Lin
Yanshan University School of Electrical Engineering
Author Profile
Chunjiang Zhang
Yanshan University School of Electrical Engineering
Author Profile
xiaoyu Zhang
Yanshan University School of Electrical Engineering
Author Profile
Fuxi Wang
Yanshan University School of Electrical Engineering
Author Profile

Abstract

With the renewable energy continuously access to the microgrid, the microgrid itself does not have the disadvantages of the inertia of the synchronous generator in the traditional grid is increasingly apparent, for which the generalized droop control (GDC) strategy is proposed. In the normal operation of the system, GDC has the advantages of large inertia and small active power overshoot, but when subjected to external frequency perturbations, the grid-supporting inverter with large virtual inertia is prone to large transient active power overshoot and oscillation. To address this problem, the article establishes small-signal models under different perturbations based on the GDC compared with the virtual synchronous generator (VSG) and further proposes two adaptive inertia control strategies: GDC adaptive inertia (GDCAI) and adaptive inertia for operation mode switching (AIOMS). By adjusting the virtual inertia appropriately, the rate of change of frequency (RoCoF) is maintained in the set range while improving the transient performance of the system, the methods of reduce-order of the system model and control parameter design is given, to reduce the frequency fluctuation while greatly reducing the active power overshoot and improving the response speed of the system. The effectiveness of the two control strategies is verified by MATLAB/Simulink simulation and StarSim hardware-in-the-loop (HIL) experiment.
01 Apr 2024Submitted to International Journal of Circuit Theory and Applications
05 Apr 2024Submission Checks Completed
05 Apr 2024Assigned to Editor
05 Apr 2024Review(s) Completed, Editorial Evaluation Pending
06 Apr 2024Reviewer(s) Assigned
14 Jul 2024Submission Checks Completed
14 Jul 2024Assigned to Editor
14 Jul 2024Review(s) Completed, Editorial Evaluation Pending
15 Jul 2024Reviewer(s) Assigned
26 Aug 2024Editorial Decision: Revise Minor
09 Oct 20242nd Revision Received
10 Oct 2024Submission Checks Completed
10 Oct 2024Assigned to Editor
10 Oct 2024Review(s) Completed, Editorial Evaluation Pending
10 Oct 2024Reviewer(s) Assigned
15 Oct 2024Editorial Decision: Accept